Hanging Instructions
You’ll need a tape measure and pencil, plus the two included double-headed hanging tacks. Press them into drywall by hand—no hammer needed. They leave only small pinholes for minimal wall damage.
Choose your height
Measure 69″ (nice) up from the floor and mark where the left hanger will sit. This recommended height works well for most spaces, but feel free to go higher or lower—especially if a lower height makes adding pins easier for your little Pinners. This is the height of the hanging points, not the center of the map.
Measure the hangers
Measure horizontally between the center teeth of the two sawtooth hangers on the back.
Mark the second spot
From your first dot, measure that same distance to the right and make a second dot at the same height. Use a level to check that your marks line up. On iPhone, open Measure → Level; on Android, download a bubble-level app. Or measure both marks from the floor instead.
Press in the hanging tacks
Press one included tack straight into each mark by hand, until its wide base sits against the wall. The space between the two heads gives the sawtooth hanger a place to rest. No hammer needed. For harder wall surfaces, use appropriate wall fixings instead.
Hang your map
Lift your Trip Pinner map onto both tacks. Make sure each sawtooth hanger sits securely in the gap between its tack’s two heads before letting go. Add your pins and enjoy. Prefer to pin sitting down? Feel free to take the map off the wall and place it on a table, then rehang it when you’re done.
